NUCLEO-F103RB: Difference between revisions
Jump to navigation
Jump to search
(Created page with "The NUCLEO-F103RB development board uses the STM32F103RBT6 as the target processor. (The is the same processor used on "Blue Pill" boards.) It was after playing with the "Blu...") |
No edit summary |
||
| Line 1: | Line 1: | ||
The NUCLEO-F103RB development board uses the STM32F103RBT6 as the target processor. (The is the same processor used on "Blue Pill" boards.) | The NUCLEO-F103RB development board uses the STM32F103RBT6 as the target processor. (The is the same processor used on "Blue Pill" boards.) | ||
It was after playing with the "Blue Pill" boards that I decided I need a REAL STMicro development board. This board is a rock solid development board with on-board ST-Link loader / debugger. | It was after playing with the "Blue Pill" boards that I decided I need a REAL STMicro development board. This board is a rock solid development board with on-board ST-Link loader / debugger. | ||
[[File:NUCLEO_large.jpg|right|thumb]] | |||
Processor: STM32F103RBT6 | Processor: STM32F103RBT6 | ||
128KB Flash | 128KB Flash | ||
Revision as of 16:49, 26 August 2020
The NUCLEO-F103RB development board uses the STM32F103RBT6 as the target processor. (The is the same processor used on "Blue Pill" boards.) It was after playing with the "Blue Pill" boards that I decided I need a REAL STMicro development board. This board is a rock solid development board with on-board ST-Link loader / debugger.
Processor: STM32F103RBT6 128KB Flash 20KB SRAM 72MHz clock Single-cycle multiplication and hardware division 2.0 to 3.6 V application supply and I/Os
Hardware
- Green LED, LD2, connected to PA5, illuminates when driven high
- Blue PushButton, B1, connects to PC13, grounding the signal when pressed
- 32,768Hz crystal oscillator, LSE, used for Real Time Clock (RTC)
- 8MHz HSE, is provided by the 8MHz crystal oscillator from the attached ST-Link, into PD0
- UART2 connects the target processor to the ST-Link, providing a USB COM port connection on the host computer. Uses PA2 for TX, and PA3 for RX.
- ST-Link connects to TCK (PA14), TMS (PA13)
Firmware
https://www.st.com/en/embedded-software/stm32cubef1.html
ST Website for the STM32F1 family: http://www.st.com/stm32f1
Getting Started
- Install STM32CubeMX - https://www.st.com/en/development-tools/stm32cubemx.html
- Install Keil uVision5 - Keil MDK Keil Pack installer: https://www.keil.com/dd2/st/stm32g031j6mx